Framing Protruding Attic Wall

If you see protruding drywall in a tall wall look to see if it s at the same height as the floor joists.

Framing protruding attic wall.

Upper or lower walls may be out of plumb or the floor assembly may have components that are not flush. As you shim and plumb each section of wall drive 16d nails through the top plate into the framing with a hammer or nail gun. Run the plywood down to the top of the knee wall. Nail the end studs to framing in the existing wall.

Allow for a top and. In wood framing basics and wall plans that have openings with cripples above the header cut and nail together the king studs and trimmers first. Purchase enough to install a stud on each end of the wall and every 16 inches between. Collar ties are horizontal members that like rafter ties extend from rafter to rafter but.

Then measure and nail the cripples into place. Score the shims with a utility knife and snap them off flush with the plate. Two by four lumber is standard for framing most walls including short walls in the attic. The plywood will create a smooth strong ceiling without having to apply drywall tape and mud to the ceiling.

In evaluating wall framing you ll be looking for walls that are out of plumb or not flat or straight. Then position and nail them to the plates. If you want your attic space to have a flat ceiling you ll need to add collar ties to the framing.